1. Which switch command enables a trunking protocol that appends a four byte CRC to the packet?
A. Switch(config-if)#switchport trunk encapsulation dot1q
B. Switch(config-if)#switchport trunk encapsulation itef
C. Switch(config-if)#switchport trunk encapsulation fddi
D. Switch(config-if)#switchport trunk encapsulation isl
Answer: D
Building Cisco Multilayer Switched Networks
2. What action should a network administrator take to enable VTP pruning on an entire management domain?
A. enable VTP pruning on any client switch in the domain
B. enable VTP pruning on every switch in the domain
C. enable VTP pruning on any switch in the management domain
D. enable VTP pruning on a VTP server in the management domain
Answer: D
3. Which statement describes Dynamic Trunking Protocol (DTP) mode ‘desirable’?
A. The interface is put into permanent trunking mode and negotiates to convert the link into a trunk link.
B. The interface actively attempts to convert the link to a trunk link.
C. The interface is put into permanent trunking mode but prevented from generating DTP frames.
D. The interface is put into a passive mode, waiting to convert the link to a trunk link. Answer: B
4. Which three statements are correct with regard to the IEEE 802.1Q standard? (Choose three.)
A. the packet is encapsulated with a 26 byte header and a 4 byte FCS
B. the IEEE 802.1Q frame format adds a 4 byte field to a Ethernet frame
C. the IEEE 802.1Q frame retains the original MAC destination address
D. the IEEE 802.1Q frame uses multicast destination of 0×01-00-0c-00-00
E. protocol uses point-to-point connectivity
F. protocol uses point-to-multipoint connectivity
Answer: BCE