5. Your customer has deployed Cisco WAAS using ACE for traffic interception. The customer reports that traffic is not being optimized. Which command would you use to troubleshoot network interception?
A. WAE-CORE# show wccp routers
B. WAE-CORE# show ip access-lists
C. ACE/Admin# show wccp routers
D. ACE/Admin# show rserver detail
E. router# show wccp services
Answer: D
Wide Area Application Services for Field Engineers
6. Refer to the exhibit. What are two possible reasons the CORE1 WAE might be displayed as “Offline”? (Choose two.)
A. The WAE is powered off.
B. The HTTPS service is disabled.
C. The Central Manager service is disabled.
D. The WAE is configured in the same VLAN as the server nodes.
Answer: AC
7. Your customer reports that traffic has never been received by the remote device after deploying Cisco WAAS using WCCPv2 in an off-path configuration. Which two parameters should you verify? (Choose two.)
A. IP SLAs
B. WAE subnet
C. router IP address
D. routing configuration
E. service group redirection
Answer: BE
8. Refer to the exhibit. This partial listing shows output from the show tfo connection summary command. Given this output, which statement is correct?
A. The local WAE policy was configured for LZ compression only; the remote WAE policy was configured for full optimization.
B. The local WAE policy was configured for LZ compression and TFO optimization; the remote WAE policy was configured for LZ compression only.
C. Both the local and remote WAE policies were configured for LZ compression only.
D. Both the local and remote WAE policies were configured for LZ compression and TFO optimization, but only LZ compression was applied.
Answer: A
